Kyocera KM-4230 Service Manual page 277

2A3/4
Maintenance
item No.
• Upper and lower drawers of the paper feed desk
U247
Display
DESK MOT
FEED CL
UPP CL
LOW CL
2 To return to the screen for selecting an item, press the stop/clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for
selecting a maintenance item No. is displayed.
U248 Setting the paper eject device
Description
Adjusts the amount of slack in the paper for the optional finisher in punch
mode when it is attached. Also sets the punch limit and displays and clears
the punch-hole scrap count. Adjusts the booklet stapling position for each
paper size when the optional booklet stitcher is attached.
Purpose
• Adjustment of the amount of slack in the paper in punch mode
Adjusts the amount of slack in the paper while in the punch section if,
in punch mode, paper jams or is Z-folded frequently due to too much
slack in the paper, or, the position of punch holes varies due to too
little slack in the paper.
• Punch limit setting
Sets the punch limit to notify the user of the time to collect punch-hole
scrap.
• Punch-hole scrap count display (clearing)
Used to manually clear the punch-hole scrap count if a message
requiring collection of punch-hole scrap is shown on the touch panel
after collection. If punch-hole scrap is collected with the copier power
turned off, the punch-hole scrap count is not cleared and
consequently this problem occurs.
• Booklet stapling position adjustment
Adjusts the booklet stapling position in the stitching mode if the
position is not proper.
3-2-68
Description
Motors and clutches
Desk drive motor (DDM)
Desk feed clutch (DFCL)
Upper desk paper feed clutch (DPFCL-U)
Lower desk paper feed clutch (DPFCL-L)
Operation
On for 5 s
On for 1 s
On for 1s
On for 1s