Kyocera KM-4230 Service Manual page 407

2A3/4
( 6 ) Adjusting the scanning start position when the DF is used
Perform the following adjustment if there is a regular error between the leading or
trailing edges of the original and the copy image.
U034 U 402
(P.3-3-18) (P.3-3-20)
Caution: Before making the following adjustment, ensure that the above adjustments
have been made in maintenance mode.
(6-1) Adjusting the DF leading edge registration
<Procedure>
Start
Enter maintenance mode.
Enter "071" using the numeric
keys and press the print key.
To adjust the DF leading
edge registration, select
"LEAD EDGE ADJ."
Press the interrupt key.
Place an original on the
DF and make a test copy.
Is the image correct?
Yes
Press the stop/clear key.
Exit maintenance mode.
End
3-3-98
U066 U403
(P.3-3-39) (P.3-3-40)
Press the print key.
The new setting is stored.
• For copy example 1,
increase the value using
No
the Up key.
• For copy example 2,
decrease the value using
the Down key.
Setting range: –32 - +32
Reference: 0
Changing the value by 1
moves the copy image
by 0.19 mm.
Increasing the value moves the copy
image backward, and decreasing it
moves the image forward.
U071
Original Copy
example 1
Figure 3-3-116
U404
(P.3-3-100)
Copy
example 2