Kyocera KM-4230 Service Manual page 390

Hide thumbs Also See for KM-4230:

Table of Contents

( 2 ) Detaching and refitting the switchback roller, duplex upper registration roller

Replace the switchback roller and duplex registration roller as follows.

• Detaching the switchback roller

1. Open the duplex unit.

2. Remove the two screws holding the duplex unit front cover and then the cover.

(only for 42 ppm)

3. Loosen the three screws at the front of the duplex unit. Remove the two screws on

the top and then the duplex unit cover.

Figure 3-3-95 Detaching the duplex unit cover

Duplex unit cover

*Illustration shows a 42 ppm.

Duplex unit front cover

Chapters

Table of Contents