Kyocera KM-4230 Service Manual page 318

3. Remove the connector and four screws holding the bypass paper feed unit, and
then the unit.
Figure 3-3-9 Detaching the bypass paper feed unit
Removing the bypass forwarding pulley
4. Remove the stop ring at the front of the bypass forwarding pulley retainer.
5. Pull out the bypass forwarding pulley shaft in the direction of the arrow, and remove
the bypass forwarding pulley.
Bypass forwarding pulley retainer
Stop ring
Figure 3-3-10 Detaching the bypass forwarding pulley
Bypass paper feed unit
Screws
Bypass forwarding pulley
Connector
Screws
Bypass forwarding pulley shaft
2A3/4
3-3-9