Kyocera KM-4230 Service Manual page 162

2A3/4
( 2 ) Installation procedure
Start
Unpack.
Remove the tapes. (42 ppm)
Remove the tapes. (52 ppm)
Remove pins holding light source
units 1 and 2.
Remove the developing unit.
Load developer.
Install the drum.
Adjust the fixing pressure.
Connect the power cord.
Carry out initial developer setting
(maintenance item U130).
Check the toner sensor control
voltage and toner feed start level
(maintenance items U131 and U156).
*1: When neither the paper feed desk nor the large paper deck is installed.
*2: When the paper feed desk or the large paper deck is installed.
*3: For 220 - 240 V specifications only.
3-1-2
Apply toner to the cleaning blade
(maintenance item U160).
Release the cleaning blade.
Exit maintenance mode.
Install a toner cartridge.
Install the feed bottom protector
(only for 42 ppm).*
Adjust the height adjuster.*
Install the copy tray*
paper size label sheet.
Make test copies.
Completion of the machine installation.
1
2
3
and