( 3 ) Adjusting the position of the side registration section
Perform the following adjustment if there is a regular error between the centers of the
original and copy image during duplex copying (second face).
<Procedure>
Start
Make a test copy at 100% and using
the largest size paper in duplex mode.
Is the center
of the image aligned with
that of original?
Yes
End
Screws
Figure 3-3-103 Adjusting the position of the side registration section
Loosen the four screws holding the
side registration section, move the
section and retighten the screws.
No
• For copy example 1, move the sec-
tion toward the machine front (
• For copy example 2, move the sec-
tion toward the machine rear (
Original
Copy
example 1
Figure 3-3-102
).
Screws
Side registration
section
*Illustration shows a 42 ppm.
2A3/4
Copy
example 2
).
3-3-87