Unit Injectors; Injector Timing; Fuel Filter; Fuel Solenoid Assembly - Arctic Cat 700 DIESEL 2015 Service Manual

Unit Injectors

To service the unit injectors, see Top-Side Components in
Engine/Transmission.

Injector Timing

 NOTE: For injector timing instructions, see Top-
Side Components in Engine/Transmission.

Fuel Filter

To replace the fuel filter, see Periodic Maintenance/Tune-
Up.

Fuel Solenoid Assembly

 NOTE: After troubleshooting the fuel solenoid (see
Electrical System) if it is determined that replacement
is necessary, use the following procedure.
REMOVING
1. Remove the right-front inner splash panel; then
remove the V-belt cooling boot from the V-belt hous-
ing.
2. Locate the fuel solenoid mounted on top of the fuel
filter head; then disconnect the spade connector from
the solenoid.
DE078A
3. Remove the banjo-fitting bolts (A) and (B) and
remove the fuel solenoid. Account for four crush
washers.
INSTALLING
1. Using new crush washers, secure the fuel solenoid to
the filter housing with banjo-fitting bolt (B) and
tighten securely.
2. Secure the fuel hose to the fuel solenoid with new
crush washers and banjo-fitting bolt (A).
3. Connect the spade connector to the solenoid.
DE061A
DE647B
DE647A
DE647A
107