Rip Card Assembly Software Error - Lexmark X945e MFP 7510 series Service Manual

7510
Step Action and questions
25 Replace the faulty ISP option. Restart the device.
Does the 900.xx error reoccur?
26 Are there any more ISP options to install?
27 Install the next ISP option. Restart the device.
Does the 900.xx error reoccur?
28 Run a job to test the option.
Does the 900.xx error reoccur?
29 Upgrade the firmware. Contact your next level of
support for the correct firmware level to use.
Restart the printer to operating mode.
Does the 900.xx error reoccur?
30 Replace the faulty ISP option. Restart the device.
Does the 900.xx error reoccur?
31 Contact your next level of support. You will need the following information for them:
• Exact 900.xx error digits and complete error message
• Printed menu settings page
• Printed network settings page
• Device error log
• A sample print file if error appears to be isolated to a single file
• File/Application used if error is related to specific print file
• Device Operating System
• Driver used (PCL/PS)
• Frequency of the occurrence of the error
901.XX RIP card assembly software error
Step
1 Perform a POR.
Does the error occur when the power is turned off/on?
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
3 Perform a POR.
Does the error occur when the power is turned off/on?
2-134
Service Manual
Check
Yes No
Go to step 31. Go to step 26.
Go to step 27 Problem
resolved.
Go to step 29. Go to step 28.
Go to step 29. Go to step 26.
Go to step 30. Go to step 26.
Go to step 31. Go to step 26.
Yes
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-84.
Go to step 3.
Replace the upper Problem solved.
printer engine card
assembly.
Go to "Upper
printer engine
card assembly
removal" on
page 4-88.
Previous
Next
Go Back
No