Transfer Belt Lift Mechanism Adjustment - Lexmark X945e MFP 7510 series Service Manual

Center setup
Step
2 Perform the center setup:
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Center setup
Does the above test pass?
3 The image density sensor is not properly set in the center
position. Ensure the image density is placed in the center
position.
Is the image density placed in the center position.

Transfer belt lift mechanism adjustment

Step
1 Access the transfer belt lift latch assembly.
1. Open the printer front door.
2. Release the transfer belt lift latch assembly.
3. Lower the transfer belt lift handle assembly.
Does the transfer belt lift handle assembly lower and
raise smoothly (without binding)?
Check
Check
Yes
Move the image Go to step 3.
density sensor
back to its original
position.
The color
registration
(RegCon)
procedure is now
complete.
Go to step 2. Repeat step 3.
Yes
Go to step 7. Go to next step.
Repair information
7510
Previous
No
Next
Go Back
No
4-277