Lexmark X945e MFP 7510 series Service Manual page 612

7510
7. Move the rear lift cable pulley (D) toward the rear of the tray to release the two tray 3 rear cables (E) from the
tray lift shaft assembly (B).
8. Remove the two tray 3 rear cables (E) from the tray lift shaft assembly (B).
9. Remove two E-clips with a prying tool securing the two small pulleys (F) on the rear of the frame assembly.
10. Remove the two small guides (G) and the two small pulleys (F).
11. Remove the E-clip with a prying tool securing the large guide (H) and the large pulley (I) to the frame
assembly.
12. Remove the large guide (H) and the large pulley (I).
13. Remove the tray 3 rear cables (E) from the bottom plate (J).
Replacement note: Before re-installing:
–
Ensure tray 3 rear cables (E) are not twisted or kinked.
–
Route the cables properly as shown in the figure.
Replacement note: Replace the cables by setting the frame assembly on its side as shown in the figure.
4-180
Service Manual
Rear
E
B
D
Previous
Next
Go Back