In/Out Setup - Lexmark X945e MFP 7510 series Service Manual

7510

In/out setup

Step
1 Perform the In/out setup:
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch In/out setup
Does the above test pass?
2 Analyze the In/out setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Is the value for all of the above settings a "0"?
3 Perform the skew rough setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew rough setup
Does the above test pass?
4-272
Service Manual
Check Yes
Perform the Go to step 2.
Center setup.
See "Center
setup" on
page 4-276.
Go to step 3. Go to step 5.
Go to step 4. Go to step 7.
Previous
No
Next
Go Back