Transfer Belt Position Failure - Lexmark X945e MFP 7510 series Service Manual

904.01 Transfer belt position failure

Step
1 Reset the transfer belt HP failure lock out condition.
1. Enter the Diagnostics Menu.
2. Touch Trans belt fail HP.
3. Touch Trans belt fail HP.
Does the transfer belt appear damaged or torn in half?
2 Check the transfer belt unit assembly for proper installation.
Is the above component properly installed?
3 Did the error occur following a developer unit replacement?
4 Is the transfer belt torn, damaged, or missing?
5 Check to ensure that the transfer belt lift mechanism is
functioning properly. See
adjustment" on page
Does the problem persist?
6 Check the transfer belt steering motor assembly for proper
operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer Motor tests
4. Touch Transfer belt steering motor.
Does the above component operate properly?
Check
"Transfer belt lift mechanism
4-277.
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
Replace the Go to the next
transfer belt. step.
If the problem
persists, go to the
next step.
Go to the next Re-install the
step. transfer belt unit
assembly.
If the problem
persists, go to the
next step.
Verify the Go to the next
developers are step.
installed correctly.
See "Developer
unit assembly
removal" on
page 4-63.
If the problem
persists, go to the
next step.
Replace the Go to the next
transfer belt. step.
Go to the next The problem is
step. resolved.
Go to step 6. Contact the next
level of support.
Diagnostic information
7510
Previous
No
Next
Go Back
2-151