Printer Left Door Damper Removal - Lexmark X945e MFP 7510 series Service Manual

7510
'
Replacement warning: When replacing the printer left door assembly (B), ensure that the duplex media
exit turn guide (F) is held in its upper-most position, or the printer left door assembly (B) will not close
properly.

Printer left door damper removal

1. Remove the rear cover assembly. See
2. Remove the rear left middle cover. See
3. Remove the MPF feed unit assembly. See
4. Remove the printer left door assembly. See
5. Remove the E-clip securing the shaft (A) to the machine.
6. Remove the shaft (A).
7. Remove the printer left door damper idler gear (B).
8. Remove the screw securing the printer left door damper (C) to the machine.
4-38
Service Manual
D
B
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
F
4-5.
4-6.
4-8.
Previous
Next
Go Back
4-36.