Rip Card Assembly Software Failure - Lexmark W850n Service Manual

Step
10 Check the MPF pick solenoid for proper operation.
1. Enter Diagnostics mode.
2. Select MOTOR TESTS.
3. Select MPF pick solenoid.
Does the MPF pick solenoid make an audible clicking
sound when activated?
11 Check the MPF pick solenoid connection.
Is the MPF pick solenoid properly connected?
12 Perform a print test.
Does the error continue?
900.XX RIP card assembly software failure
Step
1 Perform a POR.
Does the error occur when the power is turned off/on?
2 Turn the printer off for 60 seconds.
Does the error occur when the power is turned off/on again?
3 Perform a print test.
Does the error still occur?
Check
Check
Yes
Go to step 12. Go to step 11.
Replace the MPF Replace the
pick solenoid. connection.
Go to "MPF pick
solenoid / pick
lever removal"
on page 4-59.
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-119.
Yes
Go to step 2. Perform several
print tests.
If the problem
remains, go to
step 2.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-126.
Go to step 3.
Replace the Problem solved.
printer engine card
assembly.
Go to "Printer
engine card
assembly
removal" on
page 4-119.
Diagnostic information
4024-110
No
No
2-41