Scanner Manual Registration; Sensor Test (Scanner Tests) - Lexmark X945e MFP 7510 series Service Manual

7510

Scanner Manual Registration

Note: All scanner and ADF manual registration alignment verifications must be done in standard user mode,
not in configuration or diagnostic mode.
Note: You should verify the printer registration alignment before conducting the manual scanner registration
process. For more information regarding printer registration, see
You can adjust the device's scanner and ADF registration through a manual process. Perform this operation
when any of the following events occur:
•
The flatbed scanner unit assembly has been replaced.
•
The ADF unit assembly has been replaced.
•
The CCD card/lens assembly has been replaced.
•
Symptoms indicate that the scanner is not properly aligned.

Sensor Test (Scanner Tests)

To perform the Sensor Test:
1. Touch SCANNER TESTS from the Diagnostics Menu.
2. Touch Sensor Test.
The following example appears on the LCD:
Platen length APS 1
Platen length APS 2
ADF left cover interlock
ADF pre registration
ADF registration
Sheet through
ADF inverter
Tray media width 1
Tray media width 2
Tray media width 3
ADF width APS 1
ADF width APS 2
ADF width APS 3
Tray media length 1
Tray media length 2
Pick roll position HP
Document set
ADF angle
Scanner HP
Platen interlock
Press Stop to return to SCANNER TESTS.
3-24
Service Manual
"ENGINE ADJUST" on page
Previous
3-26.
Next
Go Back