Sensor (Adf Pre-Registration) Lag Jam (Inverting) - Lexmark X945e MFP 7510 series Service Manual

Step
9 Check the inverter solenoid assembly for proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Scanner Motor Tests.
4. Touch Inverter solenoid.
Does the above component operate properly?
10 Check the inverter solenoid assembly for proper
connection.
Is the above component properly connected?
11 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?
12 Place an undamaged document in the ADF, and perform a
ADF test.
Does the error remain?

294.02 Sensor (ADF pre-registration) lag jam (inverting)

Step
1 Check the original document condition.
Is the original document free of paper clips and staples as
well as damage such as creases, tears, holes or excessive
wear?
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Check
Yes
Go to step 11. Go to step 10.
Replace the Replace the
inverter solenoid connection.
assembly.
Go to "Inverter
solenoid
assembly
removal" on
page 4-146.
Replace the ADF Problem solved.
controller card
assembly.
Go to "ADF
controller card
assembly
removal" on
page 4-145.
Go to step 12.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-84.
Yes
Go to step 2. Remove damaged
original document
and replace with a
new undamaged
original document.
Perform a ADF
test. If the problem
remains, go to step
2.
Diagnostic information
7510
Previous
No
Next
Go Back
No
2-99