Transfer Belt Drive Motor Cooling Fan Removal - Lexmark X945e MFP 7510 series Service Manual

7510
7. Remove the lower printer engine card assembly (A).

Transfer belt drive motor cooling fan removal

1. Remove the rear cover assembly. See
2. Remove the rear upper cooling fan bracket assembly. See
removal" on page
3. Remove the developer / transfer roll HVPS card assembly. See
assembly removal" on page
4. Disconnect the connector from the transfer belt drive motor cooling fan (A).
5. Remove the harness clamp from the transfer belt drive motor cooling fan (A).
6. Remove the two screws securing the transfer belt drive motor cooling fan (A) to the machine.
7. Remove the transfer belt drive motor cooling fan (A).
4-92
Service Manual
B
A
"Rear cover assembly removal" on page
4-111.
4-112.
Clamps
4-5.
"Rear upper cooling fan bracket assembly
"Developer / transfer roll HVPS card
A
Connector
Previous
Next
Go Back