Lexmark X945e MFP 7510 series Service Manual page 702

7510
Step
5 Perform the skew rough setup printhead adjustment.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Cycle result values
Locate the following new values for the following settings:
Y- Skew adjustment
M- Skew adjustment
C- Skew adjustment
K- Skew adjustment
Turn the appropriate printhead adjustment screws, located
behind the waste toner cartridge, the number of clicks
(rotation until a snap sound is heard and felt) based on the
above settings.
+values require turning the screw Clockwise
- values require turning the screw Counter Clockwise.
EG: Y-Skew adjustment 10. Turn the screw CW 10 clicks.
EG: Y-Skew adjustment -10. Turn the screw CCW 10 clicks.
Have the appropriate printhead adjustment screw been
adjusted?
6 Check the image density sensor assembly connection.
Is the above component properly connected?
4-270
Service Manual
Check
Printhead adjusting screw
K C
M
Y
Yes
Re-perform step 1. Go to step 6.
If the test fails then
replace the
printhead.
See "Printhead
assembly
removal" on
page 4-104.
Once the
printhead is
replaced then re-
perform the entire
RegCon
procedure.
See "" on
page 4-264.
Go to step 7. Replace the
connection.
Previous
No
Next
Go Back