Belt edge learn test
Step
1
Perform the Belt edge learn test.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Belt edge learn
Does the above test pass?
2
Replace the transfer belt unit assembly.
See
"Transfer belt unit assembly removal" on
page
4-16.
Does the error continue?
Skew fine setup
Step
1
Perform the Skew fine setup.
1. Enter the Diagnostics Menu.
2. Touch ENGINE ADJUST.
3. Touch RegCon adjust
4. Touch Control setup cycles
5. Touch Skew fine setup
Does the above test pass?
Check
Check
Yes
Perform "Skew
Go to step 2.
setup".
See
"Skew fine
setup" on
page
4-267.
Perform "Skew
Contact next level
setup".
of support.
See
"Skew fine
setup" on
page
4-267.
Yes
Go to step 2.
Go to step 3.
Repair information
7510
Previous
No
Next
Go Back
No
4-267