Sensor (Tray 4 Feed-Out) Late Jam - Lexmark X945e MFP 7510 series Service Manual

244.00 Sensor (tray 4 feed-out) late jam

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media size setup.
Does the media size, in use, match the size set for
tray 4?
3 Check the feed roll, separation roll, and pick roll for
media tray 4.
Are the above components free of excess wear and
contamination?
4 Check the media position.
Does the media touch the sensor (tray 4 feed-out)?
5 Check the sensor (tray 4 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 4.
5. Touch Feed-out.
Does the display on the operator panel, change every
time the sensing area of the above sensor is interrupted
or blocked?
6 Check the sensor (tray 4 feed-out) for proper
connection.
Is the above component properly connected?
7 Check the media feed lift motor in media tray 4 for
proper operation.
1. Enter the Diagnostics Menu.
2. Touch MOTOR TESTS.
3. Touch Printer motor tests.
4. Touch Tray 4 media feed/lift motor.
Does the above component operate properly?
8
Check the media feed lift motor for proper connection.
Is the above component properly connected?
Check
Caution: When performing motor tests,
ensure that all cover and door interlock
switches are overridden.
Yes
Replace the Go to step 2.
damaged media with
new.
Go to step 3. Replace the media,
or change the media
size setup.
Go to step 4. Clean or replace the
feed roll, separating
roll, or pick roll.
Go to
removal" on
page
"Separation roll
removal" on
page
"Pick roll removal"
on page
Remove the media. Go to step 5.
Go to step 7. Go to step 6.
Replace the sensor Replace the
(tray 4 feed-out). connection.
Go to step 9. Skip to step 8.
Replace the media Replace the
feed lift motor. connection.
Go to "Media feed
lift motor removal"
on page 4-120.
Diagnostic information
7510
Previous
No
Next
Go Back
"Feed roll
4-115,
4-117, and
4-116.
2-61