After Image - Lexmark X945e MFP 7510 series Service Manual

Step
7 Check the printhead assembly.
Replace the printhead assembly.
Go to "Printhead assembly removal" on page
Does the error continue?
8 Check the upper printer engine card assembly.
Replace the upper printer engine card assembly.
Go to "Upper printer engine card assembly removal"
on page 4-88.
Perform a print test.
Does the error continue?

After image

Leading edge
Trailing edge
The ghost appears on the media which, may be the image from the previous page or part of the page
currently printing.
Step
1 Check the media condition.
Load new, dry, recommended media.
Re-print the defective image.
Does the error continue?
2 Check the four toner cartridges.
Re-print the defective image.
Is the image density normal?
3 Check the heat roll and the pressure roll.
Remove the fuser unit assembly.
Caution: Allow the fuser unit assembly to cool down.
Is there contamination or cracks on the heat roll and/or
pressure roll?
Check
4-104.
Check
Yes
Go to step 8. Problem solved.
Replace the RIP Problem solved.
card assembly.
Go to "RIP card
assembly
removal" on
page 4-84.
Yes No
Go to step 2. Problem solved.
Problem solved. Replace any
empty toner
cartridges.
Replace the Go to step 4.
fuser unit
assembly.
Go to "Fuser
unit assembly
removal" on
page 4-15.
Diagnostic information
7510
Previous
No
Next
Go Back
2-245