Sensor (Tray 2 Feed-Out) Late Jam (Feeding From Tray 3) - Lexmark X945e MFP 7510 series Service Manual

Step
10 Perform a print test.
Does the error continue?

243.01 Sensor (tray 2 feed-out) late jam (feeding from tray 3)

Step
1 Check the media condition.
Is the media in the tray crumpled or damaged?
2 Check the media position.
Does the media touch the sensor (tray 2 feed-out)?
3 Check the sensor (tray 2 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 2.
5. Touch Feed-out.
Does the display on the operator panel, change every
time the sensing area of the above sensor is interrupted
or blocked?
4 Check the sensor (tray 2 feed-out) for proper
connection.
Is the above component properly connected?
5 Check the sensor (tray 3 feed-out) for proper operation.
1. Enter the Diagnostics Menu.
2. Touch INPUT TRAY TESTS.
3. Touch Sensor test.
4. Touch Tray 3.
5. Touch Feed-out.
Does the display on the operator panel, change every
time the sensing area of the above sensor is interrupted
or blocked?
6
Check the sensor (tray 3 feed-out) for proper
connection.
Is the above component properly connected?
Check
Check
Yes
Replace the lower Problem solved.
printer engine card
assembly.
Go to "Lower
printer engine card
assembly removal"
on page 4-91.
Yes
Replace the Go to step 2.
damaged media with
new.
Remove the media. Go to step 5
Go to step 5. Go to step 4.
Replace the sensor Replace the
(tray 2 feed-out). connection.
Go to step 7. Go to step 6.
Replace the sensor Replace the
(tray 3 feed-out). connection.
Diagnostic information
7510
Previous
No
Next
Go Back
No
2-59