7510
Key Repeat Initial Delay
When a key is touched repeatedly, this is the delay before the key begins repeating. The delay ranges from .25
seconds to 5 seconds. The default is 1 second. Values are given in increments of .25 seconds.
To change this setting:
1. Touch Key Repeat Initial Delay from the Configuration Menu.
2. Touch
to increase the value or
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
Key Repeat Rate
This is the number of times per second that a repeating key will repeat. The range is 1–100, with a default of 15
times per second.
To change this setting:
1. Touch Key Repeat Initial Delay from the Configuration Menu.
2. Touch
to increase the value or
3. Touch Submit to save the change.
4. Touch Back to cancel and return to the Configuration Menu.
Exiting Configuration Menu
From the Configuration Menu, touch Back until a graphic appears with Exit Config Menu in the lower right
corner. Touch Exit Config Menu to exit the Configuration Menu. Resetting the Printer appears on the LCD.
The printer performs a POR, and the following graphic appears on the LCD:
3-50
Service Manual
to decrease the value.
to decrease the value.
Copy
Fax
Ready. Toner low.
Status/
Supplies
Touch any button to begin.
E-Mail
FTP
Menus
Previous
Next
Go Back