Fuser Cooling Fan Removal - Lexmark X945e MFP 7510 series Service Manual

13. Remove the 24V LVPS card bracket assembly. See
page 4-95.
14. Remove the CMYK transfer HVPS card assembly. See
on page 4-103
15. Remove the K developer transport drive motor assembly. See
assembly removal" on page
16. Remove the two connectors from the CMYK PC cartridge drive motor assembly (A).
17. Release the hook securing the access cover (B) to the machine.
18. Remove the access cover (B).
19. Remove the two screws securing the socket (C) to the machine.
20. Detach the socket (C) from the machine.
Note: The lower left screw can be accessed through the hole in the frame where the socket (B) was
detached in step 7.
21. Remove the eight screws securing the CMY PC cartridge drive motor assembly (A) to the machine.
22. When removing the CMYK PC cartridge drive motor assembly (A), ensure none of the harnesses become
damaged.
23. Remove the CMYK PC cartridge drive motor assembly (A).

Fuser cooling fan removal

1. Remove the rear cover assembly. See
2. Remove the right cover assembly. See
3. Remove the top cover assembly. See
assembly removal" on page
4. Disconnect the connector from the fuser cooling fan (A).
5. Remove the harness from the clamps.
6. Lift the fuser cooling fan (A).
4-106.
Connector
B
Screwdriver
C
access hole
"Rear cover assembly removal" on page
"Right cover assembly removal" on page
"Top cover assembly removal" on page 4-4
4-5.
"24V LVPS card bracket assembly removal" on
"CMYK transfer HVPS card assembly removal"
"K developer / transport drive motor
Connector
A
7510
4-5.
4-4.
or "Rear cover
4-101
Repair information
Previous
Next
Go Back