Lexmark X945e MFP 7510 series Service Manual page 457

21. Remove the two screws from the left transfer belt lift assembly (B).
Note: In order to remove the left transfer belt lift assembly (B), two E-clips and two washers must be
removed. The two E-clips and two washers are located inside the machine in the area where the K PC unit
is located.
Warning: Do not loose the two E-clips, four washers, and two bearings. The need to be installed on the
new left transfer belt lift assembly (B) being installed in the machine.
22. Remove the two E-clips and the two washers securing the left transfer belt lift assembly (B) to the machine.
7510
4-25
Repair information
Previous
Next
Go Back