Adf Transport Roll Assembly Removal; Sensor (Document Set) Removal - Lexmark X945e MFP 7510 series Service Manual

7510

ADF transport roll assembly removal

1. Open the ADF left cover assembly.
2. Remove the ADF front cover assembly. See
3. Remove the ADF rear cover. See
4. Remove the ADF registration motor. See
5. Remove the ADF feed drive motor assembly. See
page 4-141.
6. Remove the actuator/media guide assembly. See
page 4-159.
7. Remove the E-clip securing the manual feed drive wheel (A).
8. Remove the manual feed drive wheel (A).
9. Remove the manual feed drive belt (B).
10. Remove the E-clip securing the bushing 8 mm (C).
11. Remove the bushing 8 mm (C).
12. Remove the E-clip securing the transport roll drive gear 20T (D).
13. Remove the transport roll drive gear 20T (D).
14. Remove the bushing 8 mm (E).
15. Move the ADF transport roll assembly (F) rearward and upward.
16. Remove the ADF transport roll assembly (F).
Warning: Do not touch the rubber surface of the ADF transport roll assembly (F).

Sensor (document set) removal

1. Open the ADF left cover assembly.
2. Lift the document tray assembly.
3. Remove the ADF rear cover. See
4. Disconnect the connector from the sensor (document set) (A).
5. Release the hooks securing the sensor (document set) (A).
4-164
Service Manual
"ADF front cover assembly removal" on page
"ADF rear cover removal" on page
"ADF registration motor removal" on page
E-clip
C
A B
"ADF rear cover removal" on page
4-138.
"ADF feed drive motor assembly removal" on
"Actuator/media guide assembly removal" on
F
E-clip
D
E
Front
4-138.
Previous
4-138.
4-166.
Go Back
Next