Trunk Aluminum; Side Walls - Factory Five Racing Type 65 Coupe Assembly Manual

If the starter solenoid was mounted behind the engine, run the cable up the transmission tunnel front
wall behind where the engine will sit and to the solenoid. If the starter solenoid was mounted to the 1"
tube near the master cylinder, run the cable to the front of the floor/tunnel bend and along the edge to the
front of the driver's foot box. Run the cable under the floor to the outside of the car and up to the starter
solenoid.
Use the grommeting on the edge of the aluminum where needed to prevent cable damage.
Leave the battery cable fastened for now with zip ties everywhere so that the rear harness can be run
with the cable later. Use the insulated line clips and screws for final assembly.
Drill a 5 / " hole in the side of the passenger frame engine mount in order to attach the engine ground
16
cable.
Sand the contact area down to bare metal.
Attach the OEM braided engine ground strap on the back of the driver's side cylinder head to the 2"x 2"
tube on the frame using a ¼"x ½" screw from the engine/harness assembly. Make sure to sand the
contact area down to bare metal before attaching.

Trunk Aluminum


1 / " drill bit, silicone, rivet gun, caulk gun,
8

Mounted Aluminum, Packaged Aluminum, secondary body fasteners

Side Walls

Silicone and rivet the panels to the sides and back, do not rivet the bottom edge.
9 / " wrench,
16
202
www.factoryfive.com 508-291-3443
5 / " hex key.
16