RS-232C interface
commands), origin point settings for HP-GL (when using HP-GL commands), and transfer conditions for the RS-
232C interface. The transfer conditions for the RS-232C interface can be set from the operations panel. The
transfer condition should be set to the same in the software used and in the FC9000. If there is a mistake in the
settings an error may displayed in the plotter and lack of data can cause a malfunction. In such a case, please
* RS-232C interface depends on the sales area. For details, please contact the distributor where you purchased.
(See "Setting Origin Point When HPGL is Set")
(See "Setting the Command (COMMAND)")
(See "Connecting with RS-232C")
9-3