License Plate Light - Factory Five Racing Mk4 Roadster Assembly Manual

License plate light

Drill, ¼", ⅜" drill bits, scissors, masking tape, marker
License plate light template, license plate light and bracket.
This kit is only a collection of parts designed for use primarily as a race car. Applying the
license plate bracket does not mean that this vehicle is street legal. Factory Five Racing does not
build completed or partially completed street vehicles. If you choose to title, register and operate
your kit on public roads, you are responsible for ensuring that the vehicle you build complies
with all Federal, Sate and local laws regarding its use.
The inclusion of the license plate bracket does not indicate that this kit complies in any way with
these laws.
Bolt a license plate to the light to get the correct spacing between the handle and the light. Put the light
as high as possible. It will be tight.
Mark the trunk at the top of the light.
Remove the light.
Cut out the template in the Appendix for the license plate light and tape it in position on the trunk
dimple.
Drill the two smaller holes with a ¼" drill bit and the larger one with a ⅜" drill bit.
Test fit the light with a license plate and adjust the holes with the drill bit if needed.
366
www.factoryfive.com 508-291-3443