Configuring Snmpv3 Notification Targets - Foundry Networks IronPoint 200 User Manual

To add more subtree IDs to the filter, return to the SNMP Trap Filters page and click the Edit button.
In the Edit page, click the New button to access the Add SNMP Notification Subtree page and
configure a new subtree ID to be filtered.
Note: Only the New Filter page allows the Filter ID to be configured.
Filter ID – A user-defined name that identifies the filter. (Maximum length: 32 characters)
Subtree OID – Specifies MIB subtree to be filtered. The MIB subtree must be defined in the form
".1.2.3.4" and always start with a ".".
Filter Type – Indicates if the filter is to "include" or "exclude" the MIB subtree objects from the filter.
Note that MIB objects included in the filter are not sent to the receiving target and objects excluded
are sent.

Configuring SNMPv3 Notification Targets

An SNMP v3 notification Target ID is specified by the SNMP v3 user, IP address, and UDP port. A
user-defined filter can also be assigned to specific targets to limit the notifications received to
December 2006 © 2006 Foundry Networks, Inc.
SNMP Configuration
10-15