Foundry Networks IronPoint 200 User Manual page 134

Foundry IronPoint 200 User Guide
Default Setting
3
Command Mode
Global Configuration
Command Usage
The access point sends client authentication requests to the RADIUS server and waits for a reply.
If no reply is received within the configured timeout period, the access point continues to resend
the authentication request for the number of times set by the retransmit parameter. When the
number of retransmit attempts has expired without a reply, client authentication fails.
radius-server timeout
This command sets the interval between each retransmit attempt when sending authentication
requests to the RADIUS server.
Syntax
radius-server [secondary] timeout <number_of_seconds>
• secondary - Secondary server.
• number_of_seconds - Number of seconds the access point waits for a reply before resending
a request. (Range: 1-60)
Default Setting
5
Command Mode
Global Configuration
radius-server port-accounting
This command sets the RADIUS Accounting server network port.
Syntax
radius-server [secondary] port-accounting <port_number>
• secondary - Secondary server. If secondary is not specified, then the access point assumes
you are configuring the primary RADIUS server.
• port_number - RADIUS Accounting server UDP port used for accounting messages.
(Range: 0 or 1024-65535)
Default Setting
0 (disabled)
Command Mode
Global Configuration
Command Usage
• When the RADIUS Accounting server UDP port is specified, a RADIUS accounting session is
automatically started for each user that is successfully authenticated to the access point.
radius-server timeout-interim
This command sets the interval between transmitting accounting updates to the RADIUS server.
15-4 © 2006 Foundry Networks, Inc. November 2006