Address Filter Delete - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
Default
None
Command Mode
Global Configuration
Command Mode
• The access point supports up to 1024 MAC addresses.
• An entry in the address table may be allowed or denied access depending on the global setting
configured for the address entry default command.

address filter delete

This command deletes a MAC address from the filter table.
Syntax
address filter delete <mac-address>
mac-address - Physical address of client. (Enter six pairs of hexadecimal digits separated by
hyphens.)
Default
None
Command Mode
Global Configuration
mac-authentication server
This command sets address filtering to be performed using the local MAC address database or
using a database configured on a central RADIUS server. Use the no form to disable MAC address
authentication.
Syntax
mac-authentication server [local | remote]
• local - Authenticate the MAC address of wireless clients with the local MAC address database
during 802.11 association. If this argument is entered, all access points in the wireless realm
must be configured with the same MAC addresses to be filtered.
• remote - Authenticate the MAC address of wireless clients with a MAC address database on a
RADIUS server. If this argument is entered, the list of MAC addresses must be defined in the
RADIUS server.
Default
local
Command Mode
Global Configuration
mac-authentication session-timeout
This command sets the interval at which associated clients will be re-authenticated with the RADIUS
server authentication database. Use the no form to disable reauthentication.
18-4 © 2006 Foundry Networks, Inc. November 2006