Show History - Foundry Networks IronPoint 200 User Manual

Command Usage
• Use the ping command to see if another site on the network can be reached.
• The following are some results of the ping command:
• Normal response - The normal response occurs in one to ten seconds, depending on network
traffic.
• Destination does not respond - If the host does not respond, a "timeout" appears in ten
seconds.
• Destination unreachable - The gateway for this destination indicates that the destination is
unreachable.
• Network or host unreachable - The gateway found no corresponding entry in the route table.
• Press <Esc> to stop pinging.
Example
Foundry AP#ping 10.1.0.19
192.168.1.19 is alive
Foundry AP#
reset
This command restarts the system or restores the factory default settings.
Syntax
reset <board | configuration>
• board - Reboots the system.
• configuration - Resets the configuration settings to the factory defaults, and then reboots the
system.
Default Setting
None
Command Mode
Exec
Command Usage
When the system is restarted, it will always run the Power-On Self-Test.
Example
This example shows how to reset the system:
Foundry AP#reset board
Reboot system now? <y/n>: y

show history

This command shows the contents of the command history buffer.
Default Setting
None
December 2006 © 2006 Foundry Networks, Inc.
General System and CLI Settings
6-7