General System Commands - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
Command Group
Ethernet Interface
Management Tunnel
Radio Interface
Wireless Security
VLAN
QoS
The access mode shown in the following tables is indicated by these abbreviations: GC (Global
Configuration), IC-E (Interface-Ethernet Configuration), IC-W (Interface-Wireless Configuration), and
IC-W-VAP (Interface-Wireless VAP Configuration).

General System Commands

Command
country
configure
interface
end
exit
help
prompt
ping
reset
show history
show line
adc enable
inline-scanning
5-2
Description
Configures connection parameters for the Ethernet interface
Configures parameters for a PPPoE management tunnel on the
Ethernet interface
Configures radio interface settings
Configures radio interface security and encryption settings
Configures VLAN membership
Configures traffic priorities
Function
Sets the access point country code
Activates global configuration mode
Enters specified interface configuration mode
Returns to Exec mode from any configuration mode
Returns to the previous configuration mode or exits the CLI
Displays information on using the CLI
Customizes the command line prompt
Sends ICMP echo request packets to another node on the
network
Restarts the system
Shows the command history buffer
Shows the configuration settings for the console port
Enables and disables the ADC feature on the access point
Provides support for IronPoint Wireless Location Manager
© 2006 Foundry Networks, Inc.
Page
5-8
5-8
5-9
5-10
5-11
5-11
Mode Page
Exec 6-2
Exec 6-4
GC 6-4
GC, IC 6-4
any 6-5
any 6-5
GC 6-6
Exec 6-6
Exec 6-7
Exec 6-7
Exec 6-8
GC 6-8
GC 6-9
December 2006