System Identification Commands; System Logging Commands; System Clock Commands; Snmp Commands - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

System Identification Commands

Command
system name

System Logging Commands

Command
logging on
logging host
logging console
logging level
logging facility-type
logging clear
show logging
show event-log

System Clock Commands

Command
sntp-server ip
sntp-server enable
sntp-server date-time
sntp-server daylight-
saving
sntp-server timezone
show sntp

SNMP Commands

Command
snmp-server community
5-4
Function
Specifies the host name for the access point
Function
Controls logging of error messages
Adds a syslog server host IP address that will receive
logging messages
Initiates logging of error messages to the console
Defines the minimum severity level for event logging
Sets the facility type for remote logging of syslog
messages
Clears all log entries in access point memory
Displays the state of logging
Displays all log entries in access point memory
Function
Specifies one or more time servers
Accepts time from the specified time servers
Manually sets the system date and time
Sets the start and end dates for daylight savings time
Sets the time zone for the access point's internal clock
Shows current SNTP configuration settings
Function
Sets up the community access string to permit access to
SNMP commands
© 2006 Foundry Networks, Inc.
Mode Page
GC 11-2
Mode Page
GC 12-2
GC 12-3
GC 12-3
GC 12-3
GC 12-4
GC 12-6
Exec 12-4
Exec 12-6
Mode Page
GC 13-3
GC 13-3
GC 13-2
GC 13-3
GC 13-4
Exec 13-4
Mode Page
GC 10-3
December 2006