General System And Cli Settings; Using The General System Commands; Using The Cli - Foundry Networks IronPoint 200 User Manual

This section presents the general system commands and the command to enable and disable the
Automatic Discovery and Configuration (ADC) feature.

Using the General System Commands

The CLI commands described in this section set basic system parameters and configure general CLI
settings.
There is no Web management interface equivalent for these commands.

Using the CLI

The following table provides a summary of the CLI commands in this section.
Command
country
configure
interface
end
exit
help
prompt
ping
reset
show history
show line
adc enable
inline-scanning
December 2006

General System and CLI Settings

Function
Sets the access point country code
Activates global configuration mode
Enters specified interface configuration mode
Returns to Exec mode from any configuration mode
Returns to the previous configuration mode or exits the CLI
Displays information on using the CLI
Customizes the command line prompt
Sends ICMP echo request packets to another node on the
network
Restarts the system
Shows the command history buffer
Shows the configuration settings for the console port
Enables and disables the ADC feature on the access point
Provides support for IronPoint Wireless Location Manager
© 2006 Foundry Networks, Inc.
Chapter 6
Mode Page
Exec 6-2
Exec 6-4
GC 6-4
GC, IC 6-4
any 6-5
any 6-5
GC 6-6
Exec 6-6
Exec 6-7
Exec 6-7
Exec 6-8
GC 6-8
GC 6-9
6-1