Foundry Networks IronPoint 200 User Manual page 77

Command Mode
Global Configuration
ip https port
Use this command to specify the UDP port number used for HTTPS/SSL connection to the access
point's Web interface. Use the no form to restore the default port.
Syntax
ip https port <port_number>
no ip https port
port_number – The UDP port used for HTTPS/SSL.
(Range: 443, 1024-65535)
Default Setting
443
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same port.
• To avoid using common reserved TCP port numbers below 1024, the configurable range is
restricted to 443 and between 1024 and 65535.
• If you change the HTTPS port number, clients attempting to connect to the HTTPS server must
specify the port number in the URL, in this format:
https://device:port_number
ip https server
Use this command to enable the secure hypertext transfer protocol (HTTPS) over the Secure Socket
Layer (SSL), providing secure access (i.e., an encrypted connection) to the access point's Web
interface. Use the no form to disable this function.
Syntax
ip https server
no ip https server
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
• Both HTTP and HTTPS service can be enabled independently.
• If you enable HTTPS, you must indicate this in the URL:
https://device[port_number]
November 2006 © 2006 Foundry Networks, Inc.
Management Access Settings
9-7