Configuring The Web Server; Using The Cli - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

Configuring the Web Server

The access point allows the system Web server and secure Web server to be enabled or disabled,
and the TCP port numbers to be set.

Using the CLI

Use the ip http port and the ip https port commands to set the Web server and secure Web server
TCP ports. Use the ip http server and ip https server commands to enable the Web server and
secure Web server.
Foundry AP(config)#ip http port 49154
Foundry AP(config)#ip http server
Foundry AP(config)#ip https port 49153
Foundry AP(config)#ip https server
Foundry AP(config)#
ip http port
This command specifies the TCP port number used by the Web browser interface. Use the no form
to use the default port.
Syntax
ip http port <port-number>
no ip http port
port-number - The TCP port to be used by the browser interface. (Range: 80 or 1024-65535)
Default Setting
80
Command Mode
Global Configuration
Command Usage
• You cannot configure the HTTP and HTTPS servers to use the same port.
• To avoid using common reserved TCP port numbers below 1024, the configurable range is
restricted to between 1024 and 65535. However, the default port number is 80. To reset the
default port number, use the no ip http port command, then enter the new HTTP port number.
ip http server
This command allows this device to be monitored or configured from a browser. Use the no form to
disable this function.
Syntax
ip http server
no ip http server
Default Setting
Enabled
9-6 © 2006 Foundry Networks, Inc. November 2006