Show Interface Ethernet - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
Command Mode
Interface Configuration (Ethernet)
Command Usage
This command allows you to disable the Ethernet port due to abnormal behavior (e.g., excessive
collisions), and reenable it after the problem has been resolved. You may also want to disable the
Ethernet port for security reasons.
speed-duplex
This command configures the speed and duplex mode of the access point's Ethernet port. Use the
no form to restore the default.
Syntax
speed-duplex <auto | 10-half | 10-full | 100-half | 100-full>
• auto - Enables autonegotiation to set the speed and duplex mode
• 10-half - Forces 10 Mbps, half-duplex operation
• 10-full - Forces 10 Mbps, full-duplex operation
• 100-half - Forces 100 Mbps, half-duplex operation
• 100-full - Forces 100 Mbps, full-duplex operation
Default Setting
Autonegotiation
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When the Ethernet port is set to auto (the default), autonegotiation is enabled and the speed
and duplex mode are automatically set to match the connected device.
• If the device connected to the Ethernet port does not support autonegotiation or is forced to a
specific speed and duplex mode, the access point's Ethernet port must be manually configured
to match the settings.
• When the Ethernet port is forced to a specific speed and duplex mode, autonegotiation is
disabled.

show interface ethernet

This command displays the status for the Ethernet interface.
Syntax
show interface [ethernet]
Default Setting
Ethernet interface
Command Mode
Exec
19-2 © 2006 Foundry Networks, Inc. November 2006