Foundry Networks IronPoint 200 User Manual page 148

Foundry IronPoint 200 User Guide
filter an Ethernet protocol as management traffic, use the filter ethernet-type management-only
command. To display the current settings, use the show filters command from the Exec mode.
Foundry AP(config)#filter ethernet-type protocol ARP
Foundry AP(config)#filter ethernet-type dynamic-protocol ipv6 86dd
Foundry AP(config)#filter ethernet-type management-only protocol airfortress
Foundry AP(config)#filter ethernet-type enable
Foundry AP(config)#exit
Foundry AP#show filters
Protocol Filter Information
=========================================================
Local Bridge
AP Management
Ethernet Type Filter :ENABLED
Enabled Protocol Filters
-----------------------------------------------------------
Protocol: Airfortress
Protocol: ARP
Protocol: ipv6
===========================================================
Foundry AP#
iapp
This command enables the protocol signaling required to hand over wireless clients roaming
between different 802.11f-compliant access points. Use the no form to disable 802.11f signaling.
Syntax
iapp
no iapp
Default
Enabled
Command Mode
Global Configuration
Command Usage
The current 802.11 standard does not specify the signaling required between access points in
order to support clients roaming from one access point to another. In particular, this can create a
problem for clients roaming between access points from different vendors. This command is used
to enable or disable 802.11f handover signaling between different access points.
Also, if you are using Layer 3 roaming, IAPP must be disabled on the access points.
17-2
:ENABLED
:ENABLED
© 2006 Foundry Networks, Inc.
ISO: 0x8895 (Management-Only)
ISO: 0x0806
ISO: 0x86dd (Dynamic)
November 2006