Using The Web Management Interface; Show Snmp - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
- sysSystemUp - The access point is up and running.
- tkipSequenceError - The access point has detected replay attack.
- wirelessExternalAntenna - An external antenna has been attached or detached from the
access point.
Default Setting
All traps enabled
Command Mode
Global Configuration
Command Usage
This command is used in conjunction with the snmp-server host and snmp-server enable
server commands to enable SNMP notifications.

show snmp

This command displays the SNMP configuration settings.
Syntax
show snmp
Command Mode
Exec

Using the Web Management Interface

From the main menu, click SNMP General. To configure the access point to support SNMP
management, set SNMP to Enable, specify community names, and configure up to four host IP
addresses to send trap messages to management stations. Click Apply.
10-6 © 2006 Foundry Networks, Inc. December 2006