Foundry Networks IronPoint 200 User Manual page 94

Foundry IronPoint 200 User Guide
use the show snmp command. To view SNMP users and group settings, use the show snmp users
or show snmp group-assignments commands.
Foundry AP#show snmp groups
GroupName
SecurityModel :USM
SecurityLevel :NoAuthNoPriv
GroupName
SecurityModel :USM
SecurityLevel :AuthNoPriv
GroupName
SecurityModel :USM
SecurityLevel :AuthPriv
Foundry AP#configure
Foundry AP(config)#snmp-server engine-id 1a:2b:3c:4d:00:ff
Foundry AP(config)#snmp-server user chris RWPriv auth-proto md5 auth-passphrase
a-good-pw priv-proto des priv-passphrase a-v-good-pw
Foundry AP(config)#exit
Foundry AP#show snmp users
=============================================
UserName
GroupName
AuthType
Passphrase:****************
PrivType
Passphrase:****************
=============================================
Foundry AP#show snmp group-assignments
GroupName
UserName
Foundry AP#
snmp-server engine-id
This command is used for SNMP v3. It is used to uniquely identify the access point among all access
points in the network. Use the no form to delete the engine ID.
Syntax
snmp-server engine-id <engine-id>
no snmp-server engine-id
engine-id - Enter engine-id in hexadecimal (5 -32 characters).
Default Setting
Enabled
Command Mode
Global Configuration
10-10
:RO
:RWAuth
:RWPriv
:chris
:RWPriv
:MD5
:DES
:RWPriv
:chris
© 2006 Foundry Networks, Inc. December 2006