Foundry IronPoint 200 User Guide
client as permanently blocked until Cycle 1 of the next set of attempts expires.
ids permanently-block-intruder
Enables the ability to permanently block login attempts that failed all login cycles.
Syntax
ids permanently-block-intruder
no ids permanently-block-intruder
Default
Enabled
Command Mode
Global Configuration
Command Usage
Enable this command to permanently block MAC addresses that fail all login attempts in all the login cycles.
no
Use the
form of the command to disable this feature.
ids pre-shared-key
This command sets the maximum number of login attempts for each login cycle if the pre-shared key
authentication method is used.
Syntax
ids pre-shared-key
no ids pre-shared-key
• cycle-number – The login number of the cycle you are configuring. Enter 1, 2, 3. There is no default cycle
number.
• number-attempts – Enter a number for the maximum number of login attempts in the cycle being defined.
Enter a number from 1 – 65535. However, if this value is set below 4, some client supplicants may say
that this feature is not working, even though it is. To avoid this behavior, set the number of attempts per
cycle to 4 or more.
Default Setting
5 attempts per cycle
Command Mode
Global Configuration
Command Usage
This command sets the maximum number of attempts for a login cycle on this access point, if the pre-
shared key authentication type is used. If you do not define a value for a cycle, the default is used. Also,
entering a no ids pre-shared-key resets the number of attempts to the default value.
ids static
This command sets the maximum number of login attempts for each login cycle if the static WEP key
authentication method is used.
Syntax
ids static
<cycle-number> <number-attempts>
no ids static
• cycle-number – The login number of the cycle you are configuring. Enter 1, 2, 3. There is no default cycle
number.
16-4
<cycle-number> <number-attempts>
© 2006 Foundry Networks, Inc.
December 2006
Need help?
Do you have a question about the IronPoint 200 and is the answer not in the manual?