Wireless Client - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
Message Level
Informational
Informational

Wireless Client

Message Level
Warning
Warning
Warning
Warning
Warning
Warning
Warning
B-8
Message
<radio>: Updating wpa-preshared key
<radio>: Updating wpa-psk-type as
alphanumeric | hex
Message
Station Failed to <associate | reassociate>
(invalid mode/state): <MAC-address> for
Radio <a | b/g> VAP <vap-id>
Station Failed to <associate | reas-address>
(station not authenticated) for Radio <a | b/
g> VAP <vap-id>
Station Failed to <associate | reassociate>
(internal error): <MAC-address> for Radio
<a | b/g> VAP <vap-id>
Station Failed to authenticate (out of
sequence frame): <MAC-address> for Radio
<a | b/g> VAP <vap-id>
Station Failed to authenticate (unsupported
algorithm) for Radio <a | b/g> VAP <vap-id>
Station Failed to authenticate (invalid frame
length): <MAC-address> for Radio <a | b/g>
VAP <vap-id>
Station Failed to authenticate (WEP is
required on the AP): <MAC-address> for
Radio <a | b/g> VAP <vap-id>
© 2006 Foundry Networks, Inc.
Explanation
The pre-shared key for the specified
radio interface has been updated.
The WPA pre-shared key type for the
specified radio interface has been
changed to alphanumeric or
hexadecimal.
Explanation
The access point could not associate
the client with the specified MAC
address due to being in an initialization
or scanning state.
The access point could not associate
the client with the specified MAC
address due incomplete
authentication.
The access point failed to associate
the client with the specified MAC
address due to insufficient memory
allocation.
The access point failed to authenticate
a WEP client with the specified MAC
address due to a received frame that
was not numbered in the correct
802.11 sequence.
The access point failed to authenticate
the client with the specified MAC
address due to a mismatch in WEP
shared key settings between the
access point and the client.
The access point failed to authenticate
the client with the specified MAC
address due to a non-standard WEP
authentication frame length.
The access point failed to authenticate
a WEP client with the specified MAC
address due to WEP shared-key
authentication being enabled on the
client but not on the access point.
December 2006