Show Interface Wireless - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide
Default Setting
Interface enabled
Command Mode
Interface Configuration (Wireless-VAP)
show auto
This command displays the configuration of the access point for automatic channel and transmission
power assignment.
Syntax
show auto
Command Mode
Exec
Example:
Foundry AP#show auto
AUTO CHANNEL & TX POWER
------------------------------
Auto Refresh Interval
Number of Scans done
Time to next scan
Auto Channel Selection Mode
The "Auto Refresh Interval" shows the configured duration between scans for each radio.
The "Number of Scans done" shows the number of scans that were done since the access point rebooted
The "Time to next scan" shows the number of minutes remaining before the next scan.
The "Auto Channel Selection Mode" shows if the auto channel selection mode overlap is enabled for Radio b/g.
The characters "OVERLAP" mean the selection mode is disabled. The characters "NON-OVERLAP" appear if
the feature is enabled.
show bssid
This command displays the BSSID for each VAP interface.
Syntax
show bssid
Command Mode
Exec

show interface wireless

This command displays the status for the VAP interface.
Syntax
show interface wireless <a | g> <vap-id>
• a - 802.11a radio interface.
20-12
RADIO-A
--------------
(min) : 30
:
: 0 hrs 20 min.
:
© 2006 Foundry Networks, Inc.
RADIO-B/G
-------------
30
3 3
0 hrs 29 min.
OVERLAP
December 2006