Using The Cli - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

Using the CLI

To configure a new user account for the access point, use the user command from the CLI
configuration mode. To delete a user account, use the no user command. To display all current
configured users, use the show user command from the Normal Exec level.
Foundry AP(config)#user bob foundry 0
Foundry AP(config)#user chris guest 5
Foundry AP(config)#no user admin
Foundry AP(config)#exit
Foundry AP#show user
--------------------------------
User Name: bob
Password : *****
Privilege: Admin
User Name: chris
Password : *****
Privilege: Read-Only
--------------------------------
Foundry AP#
user
This command configures the name of the user who has management access to the access point.
Syntax
user <name> <password> <privilege>
no user <name>
• name - The name of the user.
(Length: 1-64 characters, case sensitive)
• password - The password of the user.
(Length: 1-64 characters, case sensitive)
• privilege - The access level for the user account: 0 (Admin) or 5 (Read-Only).
Default Setting
Name: admin
Password: admin
Privilege: 0 (Admin)
Command Mode
Global Configuration
Command Usage
• Up to 32 user accounts can be configured; 16 Admin users and 16 Read-Only users.
• If there is only one Admin user account configured, it cannot be deleted. To delete the default
"admin" user, first configure a new Admin user account before using the no user comand to
remove the "admin" user account.
• The password for an existing user cannot be changed without first deleting the account and
then configuring it again with the new password.
9-2 © 2006 Foundry Networks, Inc. November 2006