Foundry Networks IronPoint 200 User Manual page 86

Foundry IronPoint 200 User Guide
host command defines trap receiver hosts. To view the current SNMP settings, use the show snmp
command.
Foundry AP(config)#snmp-server enable server
Foundry AP(config)#snmp-server community alpha rw
Foundry AP(config)#snmp-server community beta ro
Foundry AP(config)#snmp-server location WC-19
Foundry AP(config)#snmp-server contact Paul
Foundry AP(config)#snmp-server host 1 192.168.1.9 alpha
Foundry AP(config)#snmp-server trap dot11StationAssociation
Foundry AP(config)#exit
Foundry AP#show snmp
SNMP Information
==============================================
Service State
Community (ro)
Community (rw)
Location
Contact
EngineId :80:00:07:e5:80:00:00:2e:62:00:00:00:18
EngineBoots:1
Trap Destinations:
1: 192.168.1.9, Community: *****, State: Enabled
2:
3:
4:
dot11InterfaceAGFail
dot11StationAssociation
dot11StationReAssociation
dot1xAuthSuccess
dot1xMacAddrAuthSuccess
iappStationRoamedFrom
localMacAddrAuthFail
configFileVersionChanged
=============================================
Foundry AP#
snmp-server enable server
This command enables SNMP management access and also enables this device to send SNMP
traps (i.e., notifications). Use the no form to disable SNMP service and trap messages.
Syntax
snmp-server enable server
no snmp-server enable server
10-2
: Enable
: *****
: *****
: WC-19
: Paul
0.0.0.0, Community: *****, State: Disabled
0.0.0.0, Community: *****, State: Disabled
0.0.0.0, Community: *****, State: Disabled
Enabled
Enabled
Enabled
dot1xAuthFail Enabled
Enabled
Enabled
Enabled
Enabled
pppLogonFail Enabled
Enabled
systemDown Enabled
micFailure Enabled
© 2006 Foundry Networks, Inc.
dot11InterfaceBFail
dot11StationAuthentication
dot11StationRequestFail
dot1xAuthNotInitiated
dot1xMacAddrAuthFail
iappContextDataSent
iappStationRoamedTo
localMacAddrAuthSuccess
sntpServerFail
radiusServerChanged
systemUp
tkipSequenceError
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
December 2006