Bridging And Traffic Filtering Commands; Ethernet Interface Commands; Management Tunnel (Pppoe) Commands - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

Bridging and Traffic Filtering Commands

Command
iapp
filter local-bridge
filter ap-manage
filter ethernet-type enable
filter ethernet-type protocol
filter ethernet-type
dynamic-protocol
filter ethernet-type
management-only
show filters

Ethernet Interface Commands

Command
shutdown
speed-duplex
show interface ethernet

Management Tunnel (PPPoE) Commands

Command
ip pppoe
pppoe ip allocation mode
pppoe ipcp dns
pppoe lcp echo-interval
pppoe lcp echo-failure
pppoe local ip
5-8
Function
Enables the protocol signaling required to hand over
wireless clients roaming between different 802.11f-
compliant access points
Disables communication between wireless clients
Prevents wireless clients from accessing the
management interface who are currently associated with
the same access point
Checks the Ethernet type for all incoming and outgoing
Ethernet packets against the protocol filtering table
Sets a filter for a specific Ethernet type
Specifies a use-defined Ethernet type filter
Sets Ethernet protocol filters to accept only management
packets destined for the access point
Shows the filter configuration
Function
Disables the Ethernet interface
Configures speed and duplex operation
Shows the status for the Ethernet interface
Function
Enables PPPoE on the Ethernet interface
Specifies how IP addresses for the PPPoE
tunnel are configured on the interface
Negotiates DNS for the PPPoE tunnel
Sets LCP echo interval for the PPPoE tunnel IC-E
Sets LCP echo timeout for the PPPoE tunnel IC-E
Sets local IP address for the PPPoE tunnel
© 2006 Foundry Networks, Inc.
Mode Page
GC 17-2
GC 17-3
GC 17-3
GC 17-3
GC 17-4
GC 17-4
GC 17-5
Exec 17-5
Mode Page
IC-E 19-1
IC-E 19-2
Exec 19-2
Mode Page
IC-E 14-2
IC-E 14-3
IC-E 14-3
14-3
14-4
IC-E 14-4
December 2006