Using The Cli; System Name - Foundry Networks IronPoint 200 User Manual

Foundry IronPoint 200 User Guide

Using the CLI

In the CLI configuration mode, use the system name command to specify a new system name. Use
the show system command from the Exec mode to display the current setting.
Foundry AP(config)#system name IronPoint-AP
Foundry AP(config)#end
Foundry AP#show system
System Information
============================================================
Serial Number
System Up time

System Name

System Location
System Contact
System Country Code
MAC Address
IP Address
Subnet Mask
Default Gateway
VLAN State
Management VLAN ID(AP): 1
ADC State
IAPP State
DHCP Client
HTTP Server
HTTP Server Port
HTTPS Server
HTTPS Server Port
Slot Status
Software Version
SSH Server
SSH Server Port
Telnet Server
============================================================
Foundry AP#
system name
This command specifies or modifies the system name for this device. Use the no form to restore the
default system name.
Syntax
system name <name>
no system name
name - The name of this host.
(Maximum length: 32 characters)
Default Setting
Foundry AP
Command Mode
Global Configuration
11-2
: ANW0338030
: 0 days, 0 hours, 6 minutes, 2 seconds
: IronPoint-AP
: attic
: Contact
: US - UNITED STATES
: 00-0C-DB-81-39-05
: 10.254.254.3
: 255.255.255.0
: 10.254.254.151
: DISABLED
: ENABLED
: DISABLED
: DISABLED
: ENABLED
: 80
: ENABLED
: 443
: Dual band(a/g)
: 01301
: ENABLED
: 22
: ENABLED
© 2006 Foundry Networks, Inc. November 2006