Radio Interface Commands - Foundry Networks IronPoint 200 User Manual

Command
pppoe remote ip
pppoe username
pppoe password
pppoe service-name
pppoe restart
show pppoe

Radio Interface Commands

Command
vap
description
closed-system
auto-refresh-rate
auto-channel-selection-
mode-overlap
speed
multicast-data-rate
channel
turbo
ssid
beacon-interval
dtim-period
December 2006
Function
Sets remote IP address for the PPPoE tunnel IC-E
Sets the user name for the PPPoE tunnel
Sets the password for the PPPoE tunnel
Sets the service name for the PPPoE tunnel
Restarts the PPPoE connection with updated
parameters
Shows information about the PPPoE
configuration
Function
Provides access to the VAP interface configuration
mode
Adds a description to the wireless interface
Prevents access from clients without a pre-configured
SSID
Allows the access point radio to scan the air waves at
the specified interval so it can automatically select a
channel.
Allows the 802.11b/g radio to select any valid channel
available, including overlapping and non-overlapping
channels
Configures the maximum data rate at which a station
can connect to the access point
Configures the maximum data rate at which the access
point transmits multicast packets on the wireless
interface
Configures the radio channel
Configures turbo mode to use faster data rate
Configures the service set identifier
Configures the rate at which beacon signals are
transmitted from the access point
Configures the rate at which stations in sleep mode
must wake up to receive broadcast/multicast
transmissions
© 2006 Foundry Networks, Inc.
Complete List of CLI Commands
Mode Page
14-5
IC-E 14-5
IC-E 14-5
IC-E 14-6
IC-E 14-6
PE 14-6
Mode Page
IC-W 20-3
IC-W- 20-4
VAP
IC-W- 20-5
VAP
IC-W- 20-5
VAP
IC-W- 20-19
VAP
IC-W 20-6
IC-W 20-6
IC-W 20-6
IC-W 20-7
IC-W- 20-8
VAP
IC-W 20-8
IC-W 20-8
5-9